RKC INSTRUMENT RB Series - When Input Scale Low (PGSL) Is Changed; When Setting Limiter High (SLH) Is Changed; When Setting Limiter Low (SLL) Is Changed; When Communication Protocol (CMPS) Is Changed

8. PARAMETER DESCRIPTION
IMR02C15-E4
8-55
 When Input scale low (PGSL) is changed
The following parameter will be automatically converted.
• Input scale high • Event 2 set value (EV2)
• Setting limiter high • Event 2 set value (EV2) [high]
• Setting limiter low • Event 2 set value (EV2’) [low]
• Set value 1 (SV1) • Event 2 differential gap
• Set value 2 (SV2) • Event 3 set value (EV3)
• Set value 3 (SV3) • Event 3 set value (EV3) [high]
• Set value 4 (SV4) • Event 3 set value (EV3’) [low]
• Setting change rate limiter (up) • Event 3 differential gap
• Setting change rate limiter (down) • Event 4 set value (EV4)
• Proportional band [heat-side] • Event 4 set value (EV4) [high]
• LBA deadband (LBD) • Event 4 set value (EV4’) [low]
• Event 1 set value (EV1) • Event 4 differential gap
• Event 1 set value (EV1) [high] • Transmission output scale high
• Event 1 set value (EV1’) [low] • Transmission output scale low
• Event 1 differential gap
 When Setting limiter high [SLH] is changed
The following parameter will be automatically converted.
• Setting limiter low • Set value 3 (SV3)
• Set value 1 (SV1) • Set value 4 (SV4)
• Set value 2 (SV2)
 When Setting limiter low [SLL] is changed
The following parameter will be automatically converted.
• Setting limiter high • Set value 3 (SV3)
• Set value 1 (SV1) • Set value 4 (SV4)
• Set value 2 (SV2)
 When Communication protocol (CMPS) is changed
The following parameter will be automatically converted.
• Device address • Data bit configuration
 When Timer time unit (TMU) is changed
The following parameter will be automatically converted.
• Timer 1 • Timer 3
• Timer 2 • Timer 4