8. PARAMETER DESCRIPTION
IMR02C15-E4
8-28
Proportional band [cool-side]
Factory default setting:
The screen is displayed.
This is a Proportional band for the cool side in Heat/Cool PID control.
Data range Factory set value
1 to 1000 % of Proportional band [heat-side]
100
Proportional band [cool-side] is not displayed when the block selection at
F06 [S.F06] (P. 8-76) is set to “1: No display” in the Engineering mode.
This parameter is displayed when in Heat/Cool PID control.
ON/OFF action of cool-side only is not possible.
Related parameters
Parameter setting mode:
• Proportional band [heat-side] (P. 8-26)
• Overlap/Deadband (P. 8-29)
Engineering mode:
• Proportional band [cool-side] (P. 8-74)
• Cool action (P. 8-125)
Pc
To Next Page
Loading...
