6. OPERATIONS OF THE BASIC FUNCTIONS
IMR02C15-E4
6-15
7. Press the key several times until Function block 00 screen is displayed.
8. Press the key several times until Mode selection (no display) screen is displayed.
Change the value in the Mode selection (no display) screen to the original value and then press
the key to store the set value.
9. To return the PV/SV monitor, press the key while pressing the key.
After a new value is displayed on the display by using and keys, if no key operation is
performed within 1 minute without pressing key, this instrument returns to the PV/SV
monitor screen and the set value will not be changed.
 Set the execution method
Set that the Startup tuning (ST) will be executed only once.
1. Change the operation mode from STOP mode to RUN mode.
Press and hold the key for 2 seconds or more at the PV/SV monitor screen, then instrument
will go to RUN mode from STOP mode.
To change from STOP mode to RUN mode, refer to 6.1 RUN/STOP Transfer (P. 6-3).
2. Press and hold the key for 2 seconds or more at PV/SV monitor screen until Parameter
setting mode is displayed.
3. Press the key several times until Startup tuning (ST) screen will be displayed.
Continued on the next page.
SET
SET
SETR/S
R/S
SET
SET
28
200
OUT1
OUT
T
DO1 DO
MAN
STOP
DO3
DO4
PV/SV monitor
SV1
0200
SV1
OUT1
OUT
T
DO1 DO
MAN
STOP
DO3
DO4
2 seconds or more
SET
Parameter setting mode
First parameter
SV1
0200
SV1
OUT1
OUT
T
DO1 DO
MAN
STOP
DO3
DO4
Parameter setting mode
Set value (SV1)
SET
Parameter setting mode
Startup tuning (ST)
STU
0000
SV1
OUT1
OUT
T
DO1 DO
MAN
STOP
DO3
DO4
28$
STOP
SV1
OUT1
OUT
T
DO1 DO
MAN
STOP
DO3
DO4
PV/SV monitor (STOP mode)
2 seconds or more
STOP lamp lights
R/S
PV/SV monitor (RUN mode)
Output (OUT1) lamp lights
28$
200
SV1
OUT1
OUT
T
DO1 DO
MAN
STOP
DO3
DO4
STOP display
Set value (SV) display
SET
Press the key to ST screen (STU)
SET
To Next Page
Loading...
Need help?
General
