Rockwell Automation POINTBlock Series User Manual

Publication 1734-UM001D-EN-P - April 2008
Configure POINT I/O Modules in RSLogix 5000 Software 191
• with overload and open load diagnostic status.
2. From the Fault/Program Action dialog, complete entries, referring to
the table for a summary of how to make these entries.
3. From the Fault/Program Action dialog, perform one of the following:
• Click another tab at the top of the dialog.
or
• Click OK, which closes the dialog.
or
• Click Cancel to return to default values.
or
• Click Apply to save changes you made on any of the dialogs and
continue to display the dialog, noting that you enable the Apply
button when you make changes to any of the dialogs.
Feature Description
Point Displays the channel numbers.
Program
Mode
• Select a value to determine the behavior of each output when the controller transitions to the Program mode.
• Make a selection from the available values for each channel:
- Off (default)
- On
- Hold
• In Hard Run only, you disable editing this feature.
Fault
Mode
• Select a value to determine the behavior of each output when communication with the controller fails.
• Select from the available values for each channel:
- Off (default)
- On
- Hold
• In Hard Run only, you disable editing this feature.

Rockwell Automation POINTBlock Series Specifications

General

Brand	Rockwell Automation
Model	POINTBlock Series
Category	I/O Systems
Language	English