Publication 1734-UM001D-EN-P - April 2008
190 Configure POINT I/O Modules in RSLogix 5000 Software
Working with Dialogs for Digital Output Modules
Read this section to complete the Fault/Program Action and Configuration
dialogs for output modules. You typically select these dialogs from the General
dialog, when you add an output module with the following entries for
connection type:
• Data
• Rack Optimization
Enter values for the Fault/Program Action and Configuration dialogs based
on output modules:
• without diagnostic status.
• with overload diagnostic status.
• with overload and open load diagnostic status.
Enter Values on the Fault/Program Action Dialog
Enter values on this dialog to configure the module output state for output
modules when the controller mode changes to Program or Fault mode. To
make these entries, follow these procedures.
1. From the General dialog, select Fault/Program Action.
You see the Fault/Program Action dialog. See the figure for the
Fault/Program Action dialog for an 8-point output module. The dialogs
for 2-point and 4-point output modules are identical except for the
number of point you can configure. Use this dialog to configure the
Program mode and Fault mode for channels for modules:
• without diagnostic status.
• with overload diagnostic status.
To Next Page
Loading...
Need help?
General
