Publication 1734-UM001D-EN-P - April 2008
188 Configure POINT I/O Modules in RSLogix 5000 Software
When you switch the controller to Hard Run, note the following:
• You disable all controls except for the Description field on the General
dialog, which remains active in all modes.
• You revert to each control that contains an edited value, including the
Description field on the General dialog, to include the following dialogs:
– General
– Connection
– Fault/Program Action
– Configuration
Working with Dialogs for Digital Input Modules
To complete entries for the dialogs for input modules proceed as follows.
1. Add an input module with these entries for connection type.
• Data
• Rack Optimization
2. From the top of the General dialog, select Configuration,
You see the Configuration dialog, which is what you use to configure the
filter for input points for the following:
• Off to On
• On to Off
The Configuration dialog displays configuration data for each channel in
individual rows in a table. Input modules support separate filter times
for Off to On and On to Off transitions. The number of input channels
varies based on the type of module as in these examples.
• A 1734-IA2 module has 2 input channels (0…1).
• A 1734-IB4 module has 4 input channels (0…3).
To Next Page
Loading...
Need help?
General
