Rockwell Automation POINTBlock Series User Manual

Publication 1734-UM001D-EN-P - April 2008
232 Configure POINT I/O Modules for DeviceNet Networks
Note that fault states include the following:
• Hold Last state
• Go to Low Clamp
• Go to High Clamp
• Go to Fault Value
7. For Enable Alarm Latch, select Enable Latching Alarms or Disable.
8. For Disable Alarm, select Alarms Enabled or Alarms Disabled.

Rockwell Automation POINTBlock Series Specifications

General

Brand	Rockwell Automation
Model	POINTBlock Series
Category	I/O Systems
Language	English