Applications
R&S
®
RTB2000
114User Manual 1333.1611.02 ─ 04
● For detailed setup:
– Tap "Setup" to open the "Mask" menu.
– Change "Width Y", "Width X" and/or "Stretch Y".
5. To save the mask for later use, tap "Save".
To load a mask
1.
Press the APPS SELECTION key.
2. Tap "Mask".
3. Tap "Load".
4. Select the mask file.
5. Tap "Load".
To perform a mask testing
1. Set up the waveform that you want to test.
2. Create or load a mask. See:
● "To create and set up a mask" on page 113
● "To load a mask" on page 114
3. If necessary, tap "Setup" and adjust the y-position of the mask
4. Set the "Actions" to be performed on violation.
5. In the mask window, tap "Run".
If the mask limits are violated, the specified action is taken. The overall result is
shown in the mask window.
Mask Testing
To Next Page
Loading...
