Rohde & Schwarz R&S RTB2004 - Page 312

Remote Control Commands
R&S
®
RTB2000
304User Manual 1333.1611.02 ─ 04
15.6.5.4 Export of History Data
The commands in this chapter use numeric suffixes:
●
CHANnel<m>: Selects the analog input channel.
●
DIGital<m>: Selects the logic channel, range 0..15
●
LOGic<p>: Selects the logic pod, range 1..2
●
BUS<b>: Selects the bus, range 1..4
EXPort:ATABle:NAME....................................................................................................304
EXPort:ATABle:SAVE.....................................................................................................304
BUS<b>:HISTory:EXPort:NAME......................................................................................305
DIGital<m>:HISTory:EXPort:NAME..................................................................................305
SPECtrum:HISTory:EXPort:NAME...................................................................................305
CHANnel<m>:HISTory:EXPort:NAME.............................................................................. 305
BUS<b>:HISTory:EXPort:SAVE.......................................................................................305
DIGital<m>:HISTory:EXPort:SAVE.................................................................................. 305
SPECtrum:HISTory:EXPort:SAVE................................................................................... 305
CHANnel<m>:HISTory:EXPort:SAVE...............................................................................305
EXPort:ATABle:NAME <ExportPath>
Parameters:
<ExportPath> String parameter
Example:
EXPort:ATABle:NAME "/USB_FRONT/EXPORT/TIMES"
EXPort:ATABle:SAVE
Saves the acquisition timestamps table to the file that is defined by the EXPort:
ATABle:NAME command.
Waveform Analysis