Rohde & Schwarz R&S RTB2004 - Page 424

Remote Control Commands
R&S
®
RTB2000
416User Manual 1333.1611.02 ─ 04
SEARch:PROTocol:CAN:FTYPe <FrameType>
Specifies the frame type to be searched for if SEARch:PROTocol:CAN:CONDition is
set to IDENtifier.
Parameters:
<FrameType> DATA | REMote | ANY
SEARch:PROTocol:CAN:ITYPe <IdType>
Selects the length of the identifier: 11 bit for CAN base frames, or 29 bits for CAN
extended frames.
The command is relevant if SEARch:PROTocol:CAN:CONDition is set to
IDENtifier, IDData, or IDERror.
Parameters:
<IdType> B11 | B29
*RST: B11
SEARch:PROTocol:CAN:ICONdition <IdCondition>
Sets the comparison condition for the identifier: If the pattern contains at least one X
(don't care), you can trigger on values equal or not equal to the specified value. If the
pattern contains only 0 and 1, you can also trigger on a range greater than or lower
than the specified value.
The command is relevant if SEARch:PROTocol:CAN:CONDition is set to
IDENtifier, IDData, or IDERror.
Parameters:
<IdCondition> EQUal | NEQual | GTHan | LTHan
*RST: EQU
SEARch:PROTocol:CAN:IDENtifier <Identifier>
Defines the identifier pattern. The pattern length is defined with SEARch:PROTocol:
CAN:ITYPe.
The command is relevant if SEARch:PROTocol:CAN:CONDition is set to
IDENtifier, IDData, or IDERror.
Parameters:
<Identifier> String containing binary pattern with max. 29 bit. Characters 0,
1, and X are allowed.
SEARch:PROTocol:CAN:DLENgth <DataLength>
Defines the length of the data pattern - the number of bytes in the pattern.
The command is relevant if SEARch:PROTocol:CAN:CONDition is set to IDData.
Serial Bus Analysis