Protocol Analysis
R&S
®
RTM20xx
196User Manual 1317.4726.02 ─ 01
After setting the "Data length" and the "Comparison" condition, you can enter the value
bit-by-bit by setting the state high, low, or don't care for each single bit. Alternatively, you
can enter a hexadecimal value for each byte.
The settings are the same as for the setup of the data trigger, see "Data Setup"
on page 190.
Remote command:
SEARch:PROTocol:CAN:DLENgth on page 421
SEARch:PROTocol:CAN:DCONdition on page 421
SEARch:PROTocol:CAN:DATA on page 421
11.5.5.2 CAN Search Results
Search results (events) are marked on the waveform and listed in the event table as usual.
Instead of the event table, you can display the frame table, where the search results are
also marked. The event flags are not saved in the csv file of the frame table.
Fig. 11-13: Search for data frames with 11 bit identifier, search results are marked in frame table and
on the decoded data
CAN (Option R&S RTM-K3)
To Next Page
Loading...
