Protocol Analysis
R&S
®
RTM20xx
195User Manual 1317.4726.02 ─ 01
If you search for remote or data frames, the search consideres also the ID type, the length
of the identifier.
The setting is only available if "Event" = "Frame" is selected.
Remote command:
SEARch:PROTocol:CAN:FRAMe on page 418
Error Setup
Selects the error type to be searched for. You can select one or more error types as
search condition.
The error types are the same as in the CAN trigger setup, see "Error <type>"
on page 188.
The setting is only available if "Event" = "Error" or "ID & Error" is selected.
Remote command:
SEARch:PROTocol:CAN:ACKerror on page 419
SEARch:PROTocol:CAN:BITSterror on page 419
SEARch:PROTocol:CAN:CRCerror on page 419
SEARch:PROTocol:CAN:FORMerror on page 420
Symbolic ID
If a label list with node names was loaded and applied in the bus configuration, you can
select simply the node name from the list instead of entering the numeric identifier.
The instrument trriggers on the identifier of the selected node.
Frame type
Selects the frame type to be searched for, if "Event" = "Identifier" is selected. You can
search for data and or remote frames.
Remote command:
SEARch:PROTocol:CAN:FTYPe on page 420
Identifier Setup
Opens the menu to set the identifier pattern, if "Event" = "Identifier" or "ID & Data" or "ID
& Error" is selected.
After setting the "ID type" and the "Comparison" condition, you can enter the value bit-
by-bit by setting the state high, low, or don't care for each single bit. Alternatively, you
can enter a hexadecimal value for each byte.
The settings are the same as for the setup of the identifier trigger, see "Identifier
Setup" on page 189.
Remote command:
SEARch:PROTocol:CAN:ITYPe on page 420
SEARch:PROTocol:CAN:ICONdition on page 420
SEARch:PROTocol:CAN:IDENtifier on page 420
Data Setup
Opens the menu to set the data pattern to be searched, if "Event" = "ID & Data" is
selected.
CAN (Option R&S RTM-K3)
To Next Page
Loading...
