Rohde & Schwarz RTM2032 - Page 433

Remote Control
R&S
®
RTM20xx
418User Manual 1317.4726.02 ─ 01
SEARch:PROTocol:CAN:ICONdition................................................................................420
SEARch:PROTocol:CAN:IDENtifier..................................................................................420
SEARch:PROTocol:CAN:DLENgth..................................................................................421
SEARch:PROTocol:CAN:DCONdition..............................................................................421
SEARch:PROTocol:CAN:DATA.......................................................................................421
SEARch:PROTocol:CAN:CONDition <SearchCondition>
Sets the event or combination of events to be searched for. Depending on the selected
event, further settings are required.
Parameters:
<SearchCondition> FRAMe | ERRor | IDENtifier | IDData | IDERror
FRAMe
Search for a frame type. Set the frame type with SEARch:
PROTocol:CAN:FRAMe.
ERRor
Search for errors of one or more error types. Set the error types
with SEARch:PROTocol:CAN:ACKerror, SEARch:
PROTocol:CAN:BITSterror, SEARch:PROTocol:CAN:
CRCerror, and SEARch:PROTocol:CAN:FORMerror.
IDENtifier
Search for identifier.
Specifiy the identifier with SEARch:PROTocol:CAN:FTYPe, 
SEARch:PROTocol:CAN:ITYPe, SEARch:PROTocol:CAN:
ICONdition, and SEARch:PROTocol:CAN:IDENtifier.
IDData
Search for identifier and data.
Set the identifier (see IDENtifier) and the data with SEARch:
PROTocol:CAN:DLENgth, SEARch:PROTocol:CAN:
DCONdition, and SEARch:PROTocol:CAN:DATA.
IDERror
Search for errors that occur with a specified identifier.
Set the identifier (see IDENtifier) and the errors to be found (see
ERRor)
*RST:
FRAM
SEARch:PROTocol:CAN:FRAMe <Frame>
Selects the frame type to be searched for.
The command is relevant if SEARch:PROTocol:CAN:CONDition is set to FRAMe.
Command Reference