Rohde & Schwarz RTM2032 - Page 435

Remote Control
R&S
®
RTM20xx
420User Manual 1317.4726.02 ─ 01
SEARch:PROTocol:CAN:FORMerror <FormError>
Searches for form errors. A form error occurs when a fixed-form bit field contains one or
more illegal bits.
The command is relevant if SEARch:PROTocol:CAN:CONDition is set to ERRor or
IDERror.
Parameters:
<FormError> ON | OFF
*RST: OFF
SEARch:
PROTocol:CAN:FTYPe
Specifies the frame type to be searched for if SEARch:PROTocol:CAN:CONDition is
set to IDENtifier.
Parameters:
<FrameType> DATA | REMote | ANY
SEARch:PROTocol:CAN:ITYPe
Selects the length of the identifier: 11 bit for CAN base frames, or 29 bits for CAN exten-
ded frames.
The command is relevant if SEARch:PROTocol:CAN:CONDition is set to
IDENtifier, IDData, or IDERror.
Parameters:
<IdType> B11 | B29
*RST: B11
SEARch:PROTocol:CAN:ICONdition <IdCondition>
Sets the comparison condition for the identifier: If the pattern contains at least one X (don't
care), you can trigger on values equal or not equal to the specified value. If the pattern
contains only 0 and 1, you can also trigger on a range greater than or lower than the
specified value.
The command is relevant if SEARch:PROTocol:CAN:CONDition is set to
IDENtifier, IDData, or IDERror.
Parameters:
<IdCondition> EQUal | NEQual | GTHan | LTHan
*RST: EQU
SEARch:PROTocol:CAN:IDENtifier <Identifier>
Defines the identifier pattern. The pattern length is defined with SEARch:PROTocol:
CAN:ITYPe.
Command Reference