Remote Control
R&S
®
RTM20xx
419User Manual 1317.4726.02 ─ 01
Parameters:
<Frame> SOF | EOF | OVERload | ERRor | DTA11 | DTA29 | REM11 |
REM29
SOF: start of frame
EOF: end of frame
OVERload: overload frame
ERRor: error frame
DTA11: data frame with 11bit identifier
DTA29: data frame with 29bit identifier
REM11: remote frame with 11bit identifier
REM29: remote frame with 29bit identifier
*RST: SOF
SEARch:PROTocol:CAN:ACKerror <AcknowledgeError>
Searches for acknowledgement errors. An acknowledgement error occurs when the
transmitter does not receive an acknowledgment - a dominant bit during the Ack Slot.
The command is relevant if SEARch:PROTocol:CAN:CONDition is set to ERRor or
IDERror.
Parameters:
<AcknowledgeError> ON | OFF
*RST: OFF
SEARch:PROTocol:CAN:BITSterror <BitStuffingError>
Searches for bit stuffing errors.
See also: "Stuff bit" on page 188.
The command is relevant if SEARch:PROTocol:CAN:CONDition is set to ERRor or
IDERror.
Parameters:
<BitStuffingError> ON | OFF
*RST: OFF
SEARch:PROTocol:CAN:CRCerror <CRCerror>
Searches for errors in the Cyclic Redundancy Check.
The command is relevant if SEARch:PROTocol:CAN:CONDition is set to ERRor or
IDERror.
Parameters:
<CRCerror> ON | OFF
*RST: OFF
Command Reference
To Next Page
Loading...
