Rohde & Schwarz RTM2032 - Page 94

Measurements
R&S
®
RTM20xx
79User Manual 1317.4726.02 ─ 01
For cursor measurements on channel, math, and reference waveforms, various mea-
surement types are available, for example, Peak, RMS, Mean und Count. Cursor mea-
surement is also possible on the results of an FFT analysis. It measures the frequencies
and levels at the cursor positions and their differences.
If MSO option R&S RTM-B1 is installed, time and count measurements can be performed
on active digital channels, and the bit values of the pods can be determined.
Available cursor measurements are:
Voltage..........................................................................................................................79
Time..............................................................................................................................80
Voltage & Time..............................................................................................................80
Ratio X..........................................................................................................................80
Ratio Y..........................................................................................................................80
Count.............................................................................................................................80
Peak Values..................................................................................................................80
RMS, Mean, σ...............................................................................................................80
Duty Ratio.....................................................................................................................81
Burst Width....................................................................................................................81
Rise Time......................................................................................................................81
V-Marker.......................................................................................................................81
Crest factor....................................................................................................................81
Voltage
Sets two horizontal cursor lines and measures the voltages at the two cursor positions
and the delta of the two values.
Cursor Measurements