Functions and settings | 8
VERSION 1 | EN-US CIRUS
®
UPT-6400 Page 37 of 104
Menu
num-
ber
Menu
item
Available
only
when the
timer is
activated
(menu
number
401)
Description Setting range
206 MAN-
UAL but-
ton
Specify the function of the Manual button in the standard
screen:
• Start heating
• Start a sealing cycle (incl. cooling phase)
• Key disabled
• Start heating
• Start sealing cy-
cle
• Disabled
207 Record
mea-
sured
values
Specify how the temperature course is shown in the
graph in the standard screen:
• Heating phase: Measured temperature values are
recorded only during the heating phase (START ac-
tive).
• Cycle: Measured temperature values are recorded
during a complete heating and cooling cycle.
• Continuous: Measured temperature values are
recorded continuously.
• Heating phase
• Cycle
• Continuous
208 Return
time
If for 30 sec no button is touched in a menu item, the sys-
tem automatically returns to the standard screen.
• 30 sec: automatic return to the standard screen after
30 sec.
• No automatic return
• 30sec
• Never
209 Screen
saver
To extend the serviceable life of the screen, the time after
which the screen goes dark can be adjusted in this menu
item.
• OFF: The display remains illuminated.
Th screen saver works only in the standard screen. The
screen is activated again when any button is touched or
when an alarm occurs.
• OFF
• 1…99 min
212 Save
recipe
Saves the current values to the selected recipe.
Press Enter to save the currently set values to the se-
lected recipe.
Refer to section Recipe control for further information.
• -1…9
213 Usable
recipe
The usable recipes can be set in this menu. A checkmark
indicates that the recipe is usable. An X indicates that the
recipe is not usable.
Refer to section Recipe control for further information.
214 Recipe
mode
When recipe mode is switched on, only the usable
recipes can be loaded. Parameters cannot be saved out-
side of the recipe.
Refer to section Recipe control for further information.
• OFF
• ON
To Next Page