Impulse Impulse analysis of the current foot selection (Section 10.9).
Zones Anatomical zones of the current foot selection (Section 10.10).
Probes
Pressure in user-defined areas of the current foot selection
(Section 10.11).
Load rate Load rate of the current foot selection (Section 10.12).
Footprint size Footprint size of the current foot selection (Section 10.13).
Risk analysis
Risk analysis gives more information about the risk of the feet in a
dynamic measurement (Section 10.14).
Gait Ratios Gait ratios analysis of the current foot selection (Section 10.15).
COP Graphs
Center of pressure graphs of the current foot selection (Section
10.16).
Foot Timing
Single foot timing analysis of the current foot selection (Section
10.17).
Full plate
Activity on the plate during the entire dynamic measurement
(Section 10.18).
Multi step Multi step analysis of the dynamic measurement (Section 10.19).
The following comparisons are available:
2D 2D roll-off comparison of the foot selections (Section 10.20).
Impulse Impulse comparison of the foot selections (Section 10.21).
Areas
Comparison of pressure distribution of the foot areas (rearfoot,
midfoot, forefoot) of the foot selections (Section 10.22).
Analyze Toolbar Each analysis also features a toolbar. The toolbar lets you control the
visualization of the analysis to better suit your needs. Depending on the type of analysis
shown, certain actions are made available:
Zooms the view to fit the center of pressure line tightly.
Zooms the view to fit its contents tightly.
Zoom in. Alternatively use the mouse's scroll wheel on the view.
Zoom out. Alternatively use the mouse's scroll wheel on the view.
Rotate the view counter clockwise.
Rotate the view clockwise.
Toggles the sensor grid. The sensor grid shows the location of the
plate sensors.
Toggles the display of the center-of-pressure of a pressure
distribution.
To Next Page
Loading...