3 – 30 HS40 Service Manual
3.6.8. Application/Preset
These settings specifically apply to the selected application.
You can select multiple items. Use the trackball and the Set button to select and check or
uncheck items.
[Figure 3.18 Setup – Imaging – Application/Preset]
3.6.8.1. Application Setting
■ Select Application
Set up the measurement application.
■ Seamless Dual Mode
Select whether or not to use Seamless Dual Mode in Dual Mode.
When checked, no space will be shown between the left and right images in the Dual Mode,
while when unchecked, a space will be shown between the left and right images.
■ Enable Doppler Cursor Mode
Select whether or not to enter Cursor Mode before Doppler Mode.
■ Enable M Cursor Mode
Select whether or not to enter Cursor Mode before M Mode.
To Next Page