Chapter 1. Introduction 1 – 19
1.2.4.2. External Peripheral Devices
These are peripheral devices that can be connected for use when needed and are connected
via the USB port located at the rear panel.
When using a peripheral device via a USB port, always turn the power off before
connecting/disconnecting the device. Connection/disconnection of USB devices
while the power is on may lead to malfunction of the system and the USB
devices.
TIP
• The console’s USB ports are located on the rear panels of both the control panel
and the console.
• We recommend that you connect USB storage devices (flash memory media,
etc.) to the ports on the control panel, and other USB peripheral devices to the
rear panel for convenience.
The following products are recommended:
■ Digital Video Printer
• Black and White: Sony UP-D897 (UP-897MD, UP-X898MD, UP-D898MD), Mitsubishi
P95DE (P95DW, P95D, P95DE)
• Color: Sony UP-D25MD, Mitsubishi CP30DW
■ USB Printer
Samsung CLP-620NDK, Samsung ML-2950
■ DVD Recorder
Sony DVO-1000MD
CAUTION
You must install a printer and drivers that are compatible with Microsoft
Windows 7 (English version). Contact Samsung Medison customer support
division for inquiries about printer driver installation.
When connecting the printer, ensure that the printer is configured under
Microsoft Windows or system setup and has been chosen as the default
printer.
Please check the port that the printer uses before connecting. Printers should
be connected to the printer port while the USB printer should be connected to
the USB port.
■ Foot Switch
• 3 Pedals HID Type
To configure the foot switch function, go to Setup > Customize > Buttons > Foot Switch.
You can individually set the Left, Middle, and Right foot switches to one of the following:
Exit, Freeze, U1, U2, U3, U4, Update, Single, or Quad.
To Next Page
Loading...