Scanning and sending via SMB/FTP
157
7. Scanning
1
Place the originals face up in the RADF or place a single original face
down on the scanner glass and close the RADF (see "Loading originals"
on page 72).
2
Press Scan to Server from the display screen.
3
Set the scan features in the Advanced, Image, or Output tabs.
4
Press the Basic tab.
5
Press Recent.
6
Press the server address to which you want to resend. Then press OK.
• Add to Address: Allows you to add a server address in the Recent results
to the Address Book.
• Delete: Allows you to delete a server address in the Recent results. Press
the server address you want to delete. Then press Delete.
7
Set the scan quality by Duplex and Resolution.
8
Press the (Start) button to scan and send the file.
If an original is placed on the scanner glass, the machine shows the
window asking if you want to place another page. Load another original
and press Yes. When you finish, press No on this window.
To Next Page
Loading...
