Scanning and sending via SMB/FTP
156
7. Scanning
4
Press the Basic tab.
5
Press the server name input area, you can enter a recipient’s server
address manually. You cannot enter an address in the second field
before entering an address in the first field.
You can also use Address Book to enter the addresses easily (see
"Setting up an Address Book" on page 193).
6
Set the scan quality by Duplex and Resolution.
7
Press (Start) on the control panel.
The machine begins scanning and then sends the scanned image to the
specified server.
If an original is placed on the scanner glass, the machine shows the
window asking if you want to place another page. Load another original
and press Yes. When you finish, press No on this window.
• To cancel the current scan job, press (Stop) on the control panel. Or
you can delete current and pending jobs using Job Status on the control
panel. Select the job you want to cancel and press Delete (see "Job
Status button" on page 32).
• While the machine is sending a scanned data, you cannot use the
machine to copy or to send a fax.
9
Resending to the last server address
To resend a file to the server address last sent to:
To Next Page
Loading...
Need help?
General