Confidential
Chapter 4 Inspect the Installation
RF4402d Series Installation Manual v1.0 111
Copyright © 2018, All Rights Reserved.
Category Check Items Criteria Result
Pass Fail
Assembly condition of a connector
Fastening condition of a connector
Checking compliance with fastening
torque value
Installation status of cable
tag
Position
Marking content
Checking tag installation method
RF Antenna installation status Checking specifications
Checking installation position
Checking fixing status
Checking gap between antennas
Cable specification Checking the specification
Installation status of
arrestor
Checking the specification
Checking installation position
Checking fixing status
Cabling Cable damage
Proper installation route
Compliance with the radius of curvature
Cable binding status Binding status
Binding interval
Checking binding materials
Cable connection Compliance with connector finishing
Installation status of cable
tag
Position
Marking content
Checking tag installation method
Checking compliance with fastening
torque value
Compliance with connector finishing
Installation status of cable
tag
Position
Marking content
Checking tag installation method
Others Reserved ports Checking port cap fastening status
Cable inlet
status/Connection of
equipment I/O port
Checking fastening status
(Conduit/Cable Gland)
Cable tray and duct Checking installation status
Status of inside/outside of
the equipment and system
surrounding area
Checking the stocking condition (waste
parts, waste materials, packing
materials, and so on)
Opinion
■
To Next Page