Sartorius Cubis MCE - Page 26

26 Operating Instructions Cubis
®
MCE
Operating Concept
Level 1 Level 2 Level 3 Description
DEVICE D.SHIELD
“Draft shield”
Only for devices
with a motorized
draft shield.
CONTROL Activate | deactivate the [Change] key for the
motorized draft shield.
IONIZER Only for devices with an ionizer: Define whether an
ionization process starts after closing the draft
shield.
INT.ADJ. Define the function of the draft shield when
starting an internal adjustment.
IONIZER
“Ionizer”
Only for devices
with an ionizer.
POWER Define the intensity of the ionization process.
DURATION Define the duration of the ionization process in
seconds.
LEVELING
“Leveling”
LEVEL Define the settings for the integrated inclination
sensor.
START Define the trigger for automatic leveling.
MOTION.S.
“Motion sensor”
CONTROL Activate | deactivate the motion sensor.
NUM.GEST.
“Number”
Define the number of possible gestures.
LEFT CMD. Define the function for the left gesture.
RIGHT.CMD. Define the function for the right gesture.
UP.CMD. Define the function for the up gesture.
DOWN.CMD. Define the function for the down gesture.
EXTRAS MENU Lock or unlock the menu’s configuration
parameters.
SIGNAL Set or deactivate the acoustic signal.
KEYS Activate | deactivate the key lock.
ON MODE
“Switch-on and
switch-off options”
Configure the device’s switch-on and switch-off
options, e.g. switch between standby mode and
operating mode.
LIGHTING Activate | deactivate the lighting for the operating
display.
DATA.OUTP.
“Data
output”
COM. SBI
“SBI
communication”
COM.OUTP. Configure the data output.
STOP.AUTO Define whether the automatic data output can be
stopped and started with the [Print] key.
AUTO.CYCL.
“Time-dependent
interval”
Define an interval for the automatic data output.
FORMAT Define the data output format (characters per line).
AUTO.TARE Activate | deactivate automatic taring after the
printout.