t Define the accuracy to be used for the weight value.
*Normal resolution: As displayed
10-fold (+ 1 dec. place): With one decimal place more than on the display
100-fold (+2 dec. places): With two decimal places more than on the display
Only with calculation of reference piece weight:
t Define whether or not the piece weight should be updated when counting.
Optimization off
*By pressing key, after prompt
Automatic updating
y An overview of all settings is displayed.
t Check all settings and change as required.
y A message asks whether you would like to add another application.
t If required, select additional applications to be combined.
y Now you will be prompted to configure the weighing and printing functions.
t Check all settings and change as required.
t Enter a short name and a description for the new task.
t To save the new task, select Save.
Executing a Task:
Parts Counting with Reference Piece Weight Calculation
D t If you haven’t already done so, go to Application Management.
y The task selection is displayed.
t Select the desired task.
or
t If the desired task is already marked, select Start.
y The last used reference piece quantity nRef is displayed.
t If you are working with a variable reference piece quantity, you must enter
or change this now.
t Place this exact amount (nRef) of the objects to be counted on the
weighing pan.
Parts Counting
106 Cubis MSU User Manual
To Next Page
Loading...
