User Management (USER)
Cubis MSU User Manual 121
Step 6: Configure Password Protection
If you assign a password, this profile cannot be used until the password has been
entered.
t Select the corresponding option to define whether the user profile is password-
protected or not.
The password will be defined in the step after next.
Only the administrator can open the user profile without the password (for exam-
ple, if the user forgets the password) and assign a different password. The adminis-
trator can remove the password protection so that a new password can be set, if
desired.
If the administrator forgets the password, please contact your Sartorius Service
Center.
Step 7: Check All Settings
t To see all settings, page down with the cursor softkeys.
t To modify a setting, press the corresponding button. This opens a screen show-
ing the options for that setting.
t If the settings are correct, select Next.
Step 8: Define the Password (if Password Protection Enabled)
y If you selected the option for password protection, you are now prompted to
enter the desired password twice.
t Select the upper button.
t Enter the desired password (minimum 4 characters, maximum 8;
only numbers and uppercase letters are permitted).
t Press the lower button, and enter the password again.
t Select Next.
Step 9: Enter User Names and Descriptions
t To enter a name for the user profile, select the User Profile Name button.
The user name is shown on the top right of the display during operation
as long as the respective user profile is active.
t Enter the name (max. 40 characters) and select OK.
t To enter a description for the user profile, select the User Description
button.
The user description can be viewed at any time during operation of the balance
by pressing the user info area on the display (see “Display”).
t Enter the description and select OK.
t To complete the process, select Save.
To Next Page
Loading...
Need help?
General
