Executing a Task: Weighing in Percent
D t If you haven’t already done so, go to Application Management.
y The task selection is displayed.
t Select the desired task.
or
t If the desired task is already marked, select Start.
t If required, enter the reference percentage (e.g., 100%) or the reference weight.
t Place the sample on the weighing pan.
In the example it is the reference sample.
y The weight value of the reference is displayed.
t To start weighing in percent, select Start.
y The values for the reference percentage and the reference weight are displayed.
t Place the next sample on the weighing pan and select Weigh.
y The weight value is displayed.
t To toggle between the display of weight and percent, select Percent
or Weigh.
96 Cubis MSU User Manual
Weighing in Percent
To Next Page
Loading...
