Schweitzer Engineering Laboratories SEL-387E - Page 233

SEL-387E Relay Settings Sheet Page 19 of 28
Global Settings (SET G Command) Date
Date Code 20080110
Close/Open Set Point 3 max (1–65000 operations) B2COP3 =
kA Interrupted Set Point 3 min (0.1–999.0 kA primary) B2KAP3 =
B REAKER 3 M ONITOR
BKR3 Trigger Equation (SEL OGIC control equation)
BKMON3 =
Close/Open Set Point 1 max (1–65000 operations) B3COP1 =
kA Interrupted Set Point 1 min (0.1–999.0 kA primary) B3KAP1 =
Close/Open Set Point 2 max (1–65000 operations) B3COP2 =
kA Interrupted Set Point 2 min (0.1–999.0 kA primary) B3KAP2 =
Close/Open Set Point 3 max (1–65000 operations) B3COP3 =
kA Interrupted Set Point 3 min (0.1–999.0 kA primary) B3KAP3 =
T HROUGH -F AULT E VENT M ONITOR
Enable Through-Fault Event Winding (N, 1, 2, 3) ETHRU =
Note: Changing setting ETHRU resets/clears through-fault event information.
Through-Fault Event Trigger (SEL OGIC control equation)
THRU =
Through-Fault I
2
t Alarm Threshold
(OFF, 0–4294967 (kA)
2
seconds)
ISQT =
A NALOG I NPUT L ABELS
Rename Current Input IAW1 (1–4 characters) IAW1 =
Rename Current Input IBW1 (1–4 characters) IBW1 =
Rename Current Input ICW1 (1–4 characters) ICW1 =
Rename Current Input IAW2 (1–4 characters) IAW2 =
Rename Current Input IBW2 (1–4 characters) IBW2 =
Rename Current Input ICW2 (1–4 characters) ICW2 =
Rename Current Input IAW3 (1–4 characters) IAW3 =
Rename Current Input IBW3 (1–4 characters) IBW3 =
Rename Current Input ICW3 (1–4 characters) ICW3 =
Rename Voltage Input VAWX (1–4 characters) VAWX =
Rename Voltage Input VBWX (1–4 characters) VBWX =
Rename Voltage Input VCWX (1–4 characters) VCWX =