Section 01 MAINTENANCE
Sub-Section 02 (PERIODIC INSPECTION CHART)
01-02-1
PERIODIC INSPECTION CHART 0
NOTE:
Servicing period is given in hours. Shaded area shows the maintenance frequency.
➀ Every 10 hours in salt water use.
➁ These items have to be initially checked after 25 hours. Thereafter, servicing to be made as specified
in this chart.
➂ Daily flushing in salt water or foul water use.
DESCRIPTION
FREQUENCY
Every
10 hours
Every
25 hours
Every
50 hours
Every 100
hours or
seasonally
Lubrication/corrosion protection of metallic components ➀
Engine ignition timing
Spark plug replacement
Throttle/choke cables, inspection/lubrication ➀
Flame arrester inspection
Carburetor adjustment including choke/throttle cable adjustments and linkage
RAVE valve cleaning (787 engine)
Water flow regulator valve inspection (787 engine)
Oil injection pump adjustment
Fuel filter and oil filter inspection
Fuel filter and oil filter replacement
Engine head bolts, retorque
Steering system inspection
Reverse system/reverse cable adjustment (if applicable)
Variable trim system (if applicable)
Fastener tightening (flame arrester support, carburetor(s), engine mount, exhaust
system, etc).
Muffler, battery and reservoir fastening devices
Fuel/oil lines, check valve and hose inspection, fuel system pressurization
Fuel/vent line pressure relief valve inspection
Inspect/clean engine drain hose ➀
Water tank trap drain inspection (GTS)
Bailer pick up inspection
Battery condition
Electrical connections (starter, battery, etc.)
Monitoring beeper
Impeller shaft reservoir oil level/oil condition Replace
Impeller condition and impeller/wear ring clearance ➁
Drive shaft boot/spline condition (both ends) ➁
PTO flywheel and mid bearing (HX/XP models only) lubrication
Water intake grate condition ➁
Hull condition
Cooling system flushing
➂
To Next Page
Loading...
Need help?
General