Section 01 MAINTENANCE
Sub-Section 05 (STORAGE)
01-05-1
STORAGE 0
Engine Draining
Check engine drain hose. Make sure there is no
sand or other particles in it and that it is not ob-
structed so that water can leave the engine. Clean
hose and fitting as necessary.
All Models Except XP and HX
TYPICAL
1. Engine drain hose
2. Exhaust outlet
XP and HX Models
TYPICAL
1. Engine drain hose
Fuel System
Sea-Doo Fuel Stabilizer (P/N 413 408 600) should
be added in fuel tank to prevent fuel deterioration
and carburetor gumming. Follow manufacturer’s
instructions for proper use.
NOTE:
Fuel stabilizer should be added prior en-
gine lubrication to ensure carburetor protection
against varnish deposit.
Always turn the fuel valve to OFF position when
storing the watercraft.
Cooling System Flushing and Engine
Internal Lubrication
Cooling system has to be flushed with fresh wa-
ter to prevent salt, sand or dirt accumulation
which will clog water passages.
Engine must be lubricated to prevent corrosion on
internal parts.
For proper procedure, refer to MAINTENANCE
01-03.
-
CAUTION
Water in engine drain hose must be free to
flow out, otherwise water could be trapped
in engine. Should water freeze in engine, se-
vere damage will occur. Check engine drain
hose for obstructions.
2
F02E02A
1
â—†
WARNING
Fuel is flammable and explosive under cer-
tain conditions. Always work in a well venti-
lated area.
F05J04A
1
To Next Page
Loading...
Need help?
General