Section 08 PROPULSION SYSTEM
Sub-Section 04 (REVERSE SYSTEM)
08-04-6
1. REVERSE position
If reverse gate needs to be readjusted, it can be
done at support with adjustment nuts. Turn cable
nuts to obtain position.
NOTE:
If reverse gate adjustment is not done ad-
equately, performance and steering control will be
reduced at reverse position.
TYPICAL
1. Support
2. Adjustment nuts
Tighten adjustment nuts and recheck gate posi-
tion.
Reinstall vent tube.
1. Install vent tube
Reinstall storage tray.
F02J0FA
1
F02J06B
1
2
â—†
WARNING
Vent tube must be in place to provide proper
bilge ventilation.
F02L14A
1
To Next Page
Loading...
Need help?
General