HF Series Generators
Configuration
CF-1018R3
15
DEFAULT CONFIGURATION
Default configuration sets some default values to each workstation. It only
should be used to re-initialize the workstation c onfiguration when the complete
configuration has been lost or it is not possible to select any workstation.
1. Enter in the GSM program and select the “Configuration” button.
2. Press the “ Default Configuration” button.
3. Exit from configuration mode by pressing the “Configuration” button, then
a double-bip will sound confirming the process.
4. It is recommended to perform a proper configuration of each workstation
in the system after a default configuration.
To Next Page
Loading...