7-13
7
Setting and Operating Outlines
Yes
Yes
Yes
General purpose
No
No
Yes
No
No Computer link
No
1 (From the preceding page)2 (From the preceding page)
Message display
PC calculation
Displaying the measurement result
(value, decision etc.)
Message display
Error display
Pattern display after correction
Parallel output (Y0 to Y15), “BUSY” OFF
External interface enabled (communications)
External interface enabled (key, parallel)
Determining the measuring time (timer stop)
Serial output
Pattern display
Positional correction “yes”
Pattern display during setting
General purpose serial output Computer link output
Waiting for a measurement start input signal or key input
- If HALT MEAS ON NG (halt operation on NG measurement) has been set to "YES" (page 9-2),
measurement will be interrupted at any point in the process if an NG measurement occurs the
same as when an error occurs.
To Next Page
Loading...