8-6
Run Menu Conditions and Settings
8
[5] Binary image display
Select "YES" or "NO" to display a binary image on the MAIN OPS MENU.
On the [MAIN OPS MENU,] move the cursor to SET-SCRN, and press the SET key.
-On the [SYSTEM SETUP] menu, move the cursor to item
1
OPS MENU
SETTING and press the SET key.
[RUN MENU SETTINGS]
YES
NO
6
SHOW BINARY
IMAGE
Description
1MONITOR OUTPUT CAM1 CAM2 CAM1&2
2CAMERA1&2
CAM1=MD CAM2=MD
3CAPTURE AN IMAGE PARTIAL-IMAGE WHOLE-IMAGE NO
4MESSAGE DISPLAY
YES(RESULT.OK) YES(RESULT.NO) NO
5PATTERN DISPLAY MEAS-RESULT- OUT NO
6SHOW BINARY IMAGE
YES NO
7SHOWCORRECTIMG
YES NO
8DISPLAY + CURSOR
NO YES MANL-MESR
9OBJ.NO.MANL MODE
NO YES
0IMAGE DISPLAY FREEZE THROUGH
qUPPER MENU
A binary image will be displayed on the MAIN OPS MENU.
Note: When the monitor camera mode has been set to the 2-
screen divided display mode (cameras 1 and 2), the
binary image will not be displayed even if "YES" is
selected.
A binary image will not be displayed on the MAIN OPS MENU.
[Operation procedure]
1. On the [RUN MENU SETTINGS] menu, move the cursor to item 6 SHOW BINARY IMAGE with the
up and down keys, and press the SET key.
2. Move the cursor to YES or NO with the left and right keys, and press the SET key.
[Display examples]
· When the display mode has been set
to YES
· When the display mode has been set
to NO
F L C1ALLC2NO
VX.X
(TYPE00)
OK
MEAS. XXXXXXms
MEAS1 CAM1 CNT-BIN-OBJ
REGST NO. 00(0〜3)
NUMBER 00006 OK
TOTAL ARA 004434 OK
MSR-CHNG REG-CHNG PC-M0NTR SET-SCRN MANL-TYP-CHG
X0〜6
:
Y0〜7
:
BUSY
:
F L C1ALLC2NO
VX.X
(TYPE00)
OK
MEAS. XXXXXXms
MEAS1 CAM1 CNT-BIN-OBJ
REGST NO. 00(0〜3)
NUMBER 00006 OK
TOTAL ARA 004434 OK
MSR-CHNG REG-CHNG PC-M0NTR SET-SCRN MANL-TYP-CHG
X0〜6
:
Y0〜7
:
BUSY
:
To Next Page
Loading...
Need help?
General