Sharp IV-S20 - Page 272

11-2
11
Setting the Input/Output Conditions
- When item 1 MEAS TRIG INP I/F is set to SERIAL.

1 MEAS TRIG INP I/F  PARALLEL SERIAL CCD-TRIG
- Items 2 and 3 are
not displayed.
- Items
3 are not
displayed.

1 MEAS TRIG INP I/F  PARALLEL SERIAL CCD-TRIG
2 START CCD SAMPLE AUTO(EDGE LEVL) PARALEL SERIAL
3 SERIAL OUTPUT NO PC-LINK SERIAL
(CCD SAMPLING=PARALLEL)

1 MEAS TRIG INP I/F  PARALLEL SERIAL CCD-TRIG
2 START CCD SAMPLE AUTO(EDGE LEVL) PARALEL SERIAL

1 MEAS TRIG INP I/F  PARALLEL SERIAL CCD-TRIG
2 START CCD SAMPLE AUTO(EDGE LEVL) PARALEL SERIAL
3
OUTPUT OBJ. TYPE PARALEL SERIAL
(CCD SAMPLING＝AUTOMATIC)
- When item 1 MEAS TRIG INP I/F is set to CCD-TRG. and item 2
START CCD SAMPLE is set to PARALLEL. 
- When item 1 MEAS TRIG INP I/F is set to CCD-TRG. and item 2
START CCD SAMPLE is set to SERIAL.
- When item 1 MEAS TRIG INP I/F is set to CCD-TRG. and item 2
START CCD SAMPLE is set to AUTO (EDGE/LEVL)
1 MEAS TRIG INP I/F PARALLEL SERIAL CCD-TRIG
3 SERIAL OUTPUT NO PC-LINK SERIAL
(INPUT=PARALLEL)
4 CHG MEAS NO.X5,X6 NO YES
5 PARALLEL INPUT X5 EXT-INP. REG-REF-IMG(MSR0 COMPARE IMAGES)
6 PARALLEL INPUT X6 EXT-INP. CHG-IMG-OUT-CAM CAM-MEAS
7OUTPUT STATUS BUSY READY
8 SERIAL CONDITIONS (TO NEXT SUB-MENU)
9 COMPUTER LINK (TO NEXT SUB-MENU)
0 GAIN OFFSET (TO NEXT SUB-MENU)
q UPPER MENU
[I/O SETTING]
T-ARA EVALUATION ADJ.(00%)
(1) The display of items
22
22
2 and
33
33
3 depends on the specification in item
11
11
1 MEAS TRIG INP I/F
Input/output condition Setting details
Select the IV-S20 output status => See page 6-15, 7-2, and 10-16.
Set the conditions on the next menu when item 3 SERIAL OUT has been
set to PC-LINK.
See section 11-7 Gain/offset adjustment.
The screen will return to the [SYSTEM SETUP] menu.
7OUTPUT STATUS
(Status output)
8SERIAL CONDITIONS
(Serial communication
conditions)
9COMPUTER LINK
(Computer link)
0GAIN OFFSET (Gain/offset)
q UPPER MENU
Set the conditions on the next menu when item 1 MEAS TRIG INP I/F has
been set to SERIAL. (general purpose serial), and when item 3 SERIAL
OUTPUT (serial output) has been set to SERIAL or PC-LINK.