Factory Default
Setting Item, Function, Setting Range
pret
/ stop
Power restore action
• Selects the program status if a power failure occurs mid-program, and it is
restored.
• Selection item:
stop Stops after power is restored.
After power is restored, stops current program control, and
returns to the Program control STOP (in Standby).
cont Continues (resumes) after power is restored.
Continues (resumes) previous program control after power is
restored.
hold Suspends after power is restored.
After power is restored, suspends (on hold) current program, and
performs control (Fixed value control) using the SV from the point
of suspension.
Pressing the RUN key cancels suspension, and program control
resumes.
s_sv
/ ///0
Step SV when program control starts
• Sets the step SV when Program control starts.
• Setting range: Scaling low limit to Scaling high limit (The placement of the
decimal point follows the selection.)
s_sl
/ pv//
Program control start type
• Selects the Program control start type.
• Selection item:
PV start, PVR start
(Fig. 8.6-7)
PV start point
When Program control starts, the step SV is
advanced to the PV, then Program control
starts.
To Next Page
Loading...
