ShopBot PRSalpha - Section 5. Control Box Installation; Introduction

Section 5: Control Box Installation • May 2, 2016
© Copyright 2016 ShopBot Tools, Inc. page 5-1
Section 5. Control Box Installation
Introduction
All power, inputs, and outputs are routed through the control box. In this section, the control box will
be mounted to the table.
Note: This section shows a conventional table with a 6” Z-axis. Tables congured for 12” and 24” axes
have an extra side rail on each side and require an alternate mounting bracket. Refer to the last page
of this manual for the alternate orientation. Control box mounting for 18” Z-axis tables is identical to
the 6” table.