Section 10: PRS Alpha Control Box Wiring • May 2, 2016
© Copyright 2016 ShopBot Tools, Inc. page 10-1
Section 10. Software Installation
Introduction
ShopBot tools are shipped with three software programs that can program, edit, and run part les.
This section covers the installation of all software and provides a basic overview of the ShopBot con-
trol software. Additional information and training can be found in the control software “Help” menu as
well as ShopBottools.com and Vectric.com.
The following software will be installed during this section:
ShopBot 3: Control software used to operate the ShopBot tool and run part les.
ShopBot Editor: Enhanced text editing software used to view and edit ShopBot part les.
VCarve Pro – ShopBot Edition: CAD/CAM software used to create and edit designs, and assign tool
paths to create part les.
Hardware
Operating computer
ShopBot installation USB drive
ShopBot tool with wiring complete
USB communication cable
To Next Page
Loading...
