Section 10: PRS Alpha Control Box Wiring • May 2, 2016
© Copyright 2016 ShopBot Tools, Inc. page 10-9
Insert the Z zero plate assembly Wago plug into the connector.
Take care to align the plug correctly, and do not force installation.
Note: This connector is also used for optional accessories such as
the 3D optical probe.
The Z zero plate kit includes two rubberized tabs which act as insu-
lators. Place one or both on the V wheel bolt below the Z zero plate.
This prevents erroneous signals to the control software.
The Z zero clip can be placed on the Wago connector or other conve-
nient location until needed.
Secure Cables
Tie up cables underneath, along crossmember, with zip ties.
To Next Page
Loading...
