FAULT DIAGNOSIS 9
8020065-ZLP4/2017-08-10|SICK
Subject to change without notice
OPERATING INSTRUCTIONS | Master Data Analyzer
Please wait until the weight is displayed.
Error 00400000 Handling error - Please remove object and start again.
wrong.
Please try again or contact your service
partner.
Please contact service partner.
too heavy.
If there was an item on the surface
during bootup, please remove the item
If the Tare button was pressed and an
item removed, please press Tare again
and continue, or if there was an item on
the surface during bootup, please
remove the item and restart the system.
Tab. 20: Status messages – Measurement status
In the operating mode with bar code scanning, messages regarding the storage status
show whether or not there is sufficient space in the temporary memory bank.
empty.
There are 0 of 1000 files in the
temporary storage.
Info 0001 0< X <950 - There are X of 1000 files in the
temporary storage.
nearly full.
There are X of 1000 files in the
temporary storage. Please connect the
system to the network where the target
Error 0003 X = 1000 The temporary storage is
full.
Please stop the data acquisition and
connect the system to the network
where the target folder located.
Tab. 21: Status messages – Storage status
In the operating mode with bar code scanning, messages regarding the transmission
status show whether the measurement data could be successfully transmitted to the
customer server.
Storage status
Transmission status
To Next Page
Loading...
Need help?
General
