SAFETY INFORMATION 2
Subject to change without notice
TRANSLATION OF THE ORIGINAL OPERATING INSTRUCTIONS| VMS6200
2.10 Safety notes
DANGER!
HAZARDOUS ELECTRICAL VOLTAGE
Touching live devices can lead to death, burns or electrical shock.
▸
Electrical work may only be performed on the system by qualified specialist
personnel.
▸
Before working on electrical components, observe the five safety rules:
▸
Disconnect.
▸
Secure against being switched back on.
▸
Ensure that there is no voltage.
▸
Ground and short-circuit.
Cover or enclose live parts in the vicinity.
WARNING!
HAZARDOUS LASER RADIATION
The 2D LiDAR sensor of the volume measurement system works with an eye-safe
infrared class 1 laser (IEC 60825-1:2014, EN 60825-1:2014). The laser beam is not
visible to the human eye.
▸
Do not open the housing.
Observe laser safety regulations.
DANGER!
Suspended loads
▸
Never enter the area under suspended loads.
▸
Pay close attention when lifting loads.
▸
Comply with lifting instructions to prevent injuries and accidents.
▸
Use suitable, undamaged lifting tools.
Wear personal protective equipment (safety helmet, safety shoes).
To Next Page
Loading...
Need help?
General
