6 COMMISSIONING
TRANSLATION OF THE ORIGINAL OPERATING INSTRUCTIONS| VMS6200
Subject to change without notice
6 Commissioning
Commissioning may only be performed by qualified persons.
• Qualified persons have the specialist training, skills, and experience, as well as
knowledge of the relevant regulations and standards, to be able to perform work
assigned to them and to identify and avoid any potential dangers independently.
• Electricians have the professional training, skills and experience, and knowledge of
the relevant standards and provisions to work on electrical systems and to detect
and avoid any potential dangers independently.
6.1 Switching on the system
▸
Establish the supply of voltage to the system components via the power supply unit in
the cabinet.
All system components automatically start up.
• Self-diagnosis is performed to check the operational readiness of the devices.
• During the power-up cycle, the status indicators show the device status.
NOTE! The system in which the VMS6200 volume measurement system is integrated
is put into operation via the higher-level control.
Internal check for
operational readiness