COMMISSIONING 6
Subject to change without notice
TRANSLATION OF THE ORIGINAL OPERATING INSTRUCTIONS| VMS6200
If no dimensions can be calculated, this may be because the system parameterization
does not match the physical conditions.
▸
Check the trigger control settings in the MSC800. The trigger must be set to
Active Low.
▸
Check whether the encoder parameters entered for the MSC800 are consistent with
the VMC800 parameters.
▸
Check the configuration of the master LMS. The master LMS must receive the encoder
signal.
Check that the time stamp has been activated.
6.6 Optimizing the measurement results
If necessary, the measurement results can be optimized even further.
The length measurement (x-coordinate) is adjusted by changing the encoder resolution in
the Encoder Resolution field under ALISDIM
Parameter
Increment Configuration.
• If the measurement result is greater than the actual length value, reduce the resolution
(e.g., by 0.05 mm).
• If the measurement result is smaller, increase the resolution accordingly.
The width measurement is adjusted by changing the y-coordinate for the volume
measurement devices under ALISDIM
Parameter
External Sensors.
• If the measurement result is smaller than the actual width value, reduce the
Y coordinate of Sensor 1 and increase the Y coordinate of Sensor 2.
• If the measurement result is greater, do the opposite.
▸
NOTE! Adjust the two sensors symmetrically by decreasing or increasing the
Y coordinate of each by the same value.
▸
When adding/subtracting, pay attention to the signs of the Y coordinates.
The width measurement is adjusted by changing the Z coordinate for the volume
measurement devices under ALISDIM
Parameter
External Sensors.
• If the measurement result is smaller than the actual height value, reduce the
Z coordinates of both sensors by the same value.
• If the measurement result is greater, increase the Z coordinate.
If no dimensions are
calculated
Optimizing the length
measurement
Optimizing the width
measurement
Notes
Optimizing the height
measurement