7 MAINTENANCE AND REPAIR
TRANSLATION OF THE ORIGINAL OPERATING INSTRUCTIONS| VMS6200
Subject to change without notice
▸
Position the new MSC800 system controller inside the cabinet.
▸
Pull the controller to the left and secure it to the cabinet using the fixing screw.
▸
Place the terminal blocks, together with the cabling, back inside the designated slots.
▸
Plug the Ethernet cables into the designated connectors.
▸
Select the same position for the microswitch as in the removed controller.
▸
Switch on the supply voltage. The MSC800 starts and, after initialization, loads the
parameter set stored on the microSD card.
Check that the DEVICE READY and SYSTEM READY LEDs have lit up again.
Installing
the MSC800
To Next Page
Loading...
