7 MAINTENANCE AND REPAIR
TRANSLATION OF THE ORIGINAL OPERATING INSTRUCTIONS| VMS6200
Subject to change without notice
Fig. 50: Transferring the USB stick
▸
Remove the USB stick with the saved parameter set from the slot on the defective
VMC800 and insert it into the new device.
▸
Mount the VMC800 in the cabinet.
▸
Tighten the four fixing screws and check that the device is seated securely.
▸
Reattach the cables and screw them in place.
▸
Switch on the supply voltage. The VMC800 starts and, after initialization, loads the
parameter set stored on the USB stick.
Check that the power LED is lit up green.
Transferring
the USB stick
Installing
the VMC800
To Next Page
Loading...
