Siemens ET 200pro - Page 100

Connection
4.9 Connecting the IM 154-4 PN High Feature Interface Module with CM IM PN PP Cu
ET 200pro distributed I/O system
100 Operating Instructions, 03/2013, A5E00335544-08
Required tools
● Screwdriver
● Stripping tool for wiring the push-pull cable connector, if you are fabricating your own
cables.
Required accessories
● Preassembled cables with push-pull cable connector for 1L+/2L+ and RJ45. The cables
are available in various lengths from appropriate manufacturers.
● If you are fabricating your own cables:
– 5-wire cable and push-pull cable connector for 1L+/2L+
– 4-core, shielded cable (bus cable) and push-pull cable connector for RJ45
Note
Refer to the manufacturer's documentation if you are fabricating the cables with the
push
-pull cable connectors.