Siemens ET 200pro - Page 354

Digital electronic modules
14.5 Digital electronic module 4 DO DC 24V/2.0A High Feature (6ES7142-4BD00-0AB0)
ET 200pro distributed I/O system
354 Operating Instructions, 03/2013, A5E00335544-08
Technical specifications
Diagnostic functions
• Group error display
Red LED (SF)
• Channel error display
Red LED, per channel; combined with green
status LED
• Diagnostic information can be read
Yes
Monitoring for
• Short-circuit
Yes; per channel
• Wire break
Yes; per channel
Actuator selection data
Output voltage
• Rated value
24 V DC
• With "1" signal
Min. 2L+ (-0.8 V)
Output current
• With "1" signal
2 A
• With "0" signal (residual current)
Max. 0.5 mA
Load resistance range
12 Ω to 4 kΩ
Lamp load
Max. 10 W
Wiring 2 outputs in parallel
• For redundant control of a load
Supported
• For performance increase
No
Control of a digital input Possible; electrical isolation between 1L+ and
2L+ no longer given, because 1M and 2M are
bridged.
Switching frequency
• With resistive load
100 Hz
• With inductive load
0.5 Hz
• With lamp load
1 Hz
Limiting (internal) of inductive shut-down voltage
Typ. 2L+ (-53 V)
See also
Digital electronic modules (Page 329)
CM IO 4 x M12 Inverse connection module for electronic modules (Page 265)
CM IO 8 x M12 connection module for electronic modules (Page 267)