Siemens ET 200pro - Page 88

Connection
4.6 Connecting the Interface Module to a CM IM DP ECOFAST Cu Connection Module
ET 200pro distributed I/O system
88 Operating Instructions, 03/2013, A5E00335544-08
Pin assignment of the ECOFAST cable connector
View of the ECOFAST cable connector
Terminal
Assignment X01 and X02
Feed for X01
A
PROFIBUS DP signal A
B
PROFIBUS DP signal B
1
1L+ electronics/encoder supply
2
Ground for electronics/encoder supply 1M
3
Ground for load voltage supply 2M
4
2L+ load voltage supply
Forwarding X02
A
PROFIBUS DP signal A
B
PROFIBUS DP signal B
1
1L+ electronics/encoder supply
2
Ground for electronics/encoder supply 1M
3
Ground for load voltage supply 2M
4 2L+ load voltage supply
Note
The cable shield support is described in the Hardware Installation Instructions for the
ECOFAST cable connector.