Connection
4.7 Connecting the Interface Module to the CM IM DP M12, 7/8" Connection Module
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
93
View of the M12 and 7/8" cable connectors
* The voltage may only be used to supply the external terminating resistor. The voltage must not be
looped through to the next connector with a cable.
** We recommend that you connect the functional earth via the M12 thread (because it has a larger
surface area than terminal 5).
Note
The cable shield support is described in the Hardware Installation Instructions for the M12
cable connector.
To Next Page
Loading...
