Expanding and assigning parameters to the device
6.6 Drives
SIMATIC IPC647E
112 Operating Instructions, 11/2018, A5E45589180-AA
6.6.2.2 Permissible expansion for temperature range 0 °C to 45 °C
Note
If the device is permanently installed or mo
unted on telescopic rails, or operated as a tower,
it may only be subjected to vibration stress during operation as described below:
The restrictions do not apply for the use of SSD.
The maximum permitted power loss of the expansion cards amounts to 55
W.
You can install the following drives in the Type B drive cage at various mounting locations.
You can find information on the mounting locations under:
● Drive cage type B (Page 18)
Installation options
The following figure gives you an overview of the installation options for drives.
Drive in drive bay for internal
robust installation
ve type "SATA" is possible
1 or 2 SSDs permanently in-
stalled
* Only SATA 3.5"
The maximum permitted power loss of the expansion cards amounts to 55 W.
● 10 Hz to 58 Hz: 0,0375 mm
● 58 Hz to 500 Hz: 5 m/s
2
Vibrations may not exceed 500 Hz.
To Next Page
Loading...
Need help?
General
